The spiral chute is an important mineral processing machine and equipment. Regular maintenance and maintenance of the spiral chute is also the key to ensuring the long-term stable operation of the equipment. By mastering the operating procedures of the spiral chute, mineral processing companies can significantly improve mineral processing efficiency, reduce production costs, and thus obtain better economic benefits.

The daily maintenance of the spiral chute

1. Patrol inspection

Pay close attention to the feeding and sorting of ore; Check and remove the slag, grass and other impurities in the trough frequently; Wash the trough surface frequently to ensure that the slurry covers the entire trough surface; The inner ring of the chute should be brushed frequently to prevent rust; Pay attention to cleaning; Prevent the ore feeding pipeline from being blocked.

2. Preventive maintenance

Separate the mined minerals in advance to prevent debris and large particles from accumulating on the spiral trough surface, causing difficulty in sorting or unqualified sorting.

3. Check the rubber

When cleaning the trough, pay attention to check whether the rubber has any wear or punctures, and whether there is any leakage or seepage at the bottom. If there is any wound, it should be repaired or replaced in time.

4. Check the welds and screws

Pay attention to whether there are any open welds at each weld, and whether the connecting rod lead screw is loose. If there is an open weld, repair it, and tighten the loose screws.

5. Avoid heavy pressure and corrosion

Do not walk on the trough surface or place heavy or sharp objects, and do not sprinkle grease, alkaline, and acidic substances on the rubber to avoid corrosion of the rubber.

6. Anti-weathering from the sun

When not in use for a long time, you can put some sand in the groove to prevent the rubber from being weathered by the sun.

7. Lubrication

Do a good job of lubrication, apply butter frequently, and check the gear oil of the reducer. Check and apply butter every 15 days or so, and check the gear oil every 3 months.