A spiral sand washer is a vertical composite machine. When installing, find the vertical-horizontal line, and choose a firm and stable foundation for fixing the sand washer. To ensure the normal operation of the spiral sand washer, the installation and commissioning process of the equipment must be strictly controlled. Summary of the problems of the spiral sand washing machine.

Before the sand washing machine is operated, it must be trial run, and after the equipment is running smoothly, add materials for the operation. When adding materials by the regulations, always observe the operation of the equipment in time, and if there is a problem, it should be corrected in time.

1. The phenomenon of turning over flowers when washing sand

The phenomenon that the spiral sand washer has turned over is that the speed is too high. At this time, the speed should be adjusted. If the speed is adjusted in place, there is still the phenomenon of turning over, then the horizontal axis of the spinal disc is not fixed. Carry out the parking in order, stop and check the faults and remove them before they can continue the operation.

2. The discharge port is blocked

This is a problem that is likely to occur in the operation of the spiral sand washer. Most of the reasons are due to the granularity of the sand in the slurry of the sand washer being too fine, and the single feeding amount is suddenly increased, resulting in siltation of the discharge port. Materials are not conducive to the operation of the equipment. When the spiral sand washer is in operation, if an accident occurs, it should be stopped in time. First, stop feeding and open all the discharge ports to avoid siltation. Only after cleaning the sand washer with clean water can the operation be carried out.